Fendolite-MII is a factory-made premix of vermiculite and Portland cement, supplied in 20 kg bags and mixed with clean water on site. It is one part of a system. On structural steel in a petrochemical plant that system is a primer, a keycoat, plastic coated galvanised mesh, the Fendolite itself and a topcoat.
The layers, in order
- Primed steel. The steel is blast cleaned and primed before the fire protection goes on. For storage spheres Promat specify blast cleaning to SA 2.5 and a two-pack epoxy system.
- Weld pins. Promat helical CD weld pins are welded to the steel at a maximum of 400 mm centres in a diamond pattern to carry the mesh. The primer is made good around each pin.
- Keycoat. One coat of PSK-101 at 100 to 150 microns wet film thickness, or a splatter coat of SBR bonding latex mixed with Fendolite-MII.
- Mesh. 50 mm x 50 mm plastic coated galvanised mesh, fixed to the pins and pulled away from the steel so that it sits in the middle third of the finished thickness.
- Fendolite-MII. Sprayed to the specified thickness in as few coats as possible. The final coat is at least 8 mm thick to avoid cracking.
- Finish. The surface is floated to close the texture, and top surfaces are sloped so that water runs off.
- Topcoat. Two coats of Topcoat 200 at 150 to 200 microns wet film thickness per coat, once the Fendolite has cured and dried.
- Mastic seal. A polysulphide or silicone seal where the Fendolite meets bare steel, applied after the topcoat. Promat call for a U-shaped groove about 10 mm wide and deep, cut within 24 to 48 hours of application, to take the sealant.

PSK-101 or an SBR splatter coat
PSK-101 is a water based synthetic latex that bonds Fendolite-MII to surfaces it would not otherwise key to. Promat require it on galvanised steel, zinc silicate primers, alkyd primers, unknown coatings and glossy paints such as polyurethane.
A splatter coat of SBR bonding latex mixed with Fendolite-MII can be used instead on steel with a compatible primer and on concrete. Promat recommend it on large flat areas such as the webs of deep beams. On vessel skirts both are sometimes used together.
Two-pack epoxy primers are generally compatible, but they chalk in sunlight and can lose adhesion. Promat advise protecting an epoxy primer from UV between priming and spraying.
Can the mesh be left out?
Sometimes. Promat allow a mesh-free application only indoors, with no vibration and no risk of impact, on a sound substrate, and after the client or their engineer has agreed it. PSK-101 is always used in that case. If there is any doubt, fit the mesh.
Who can apply it
Fendolite-MII is supplied to contractors that Promat recognise and have trained. If you need the work carried out, our sister company Firetech (UK) Limited is a licensed applicator.
