Technical library / Applications

Fendolite-MII on storage spheres

How a sphere is coated when nothing can be welded to the shell: collars and bands, floating support rings and a continuous mesh.

Rope access team spraying fire protection on a storage sphere

Welding is rarely allowed on the shell of a storage sphere, so the mesh cannot be pinned in the usual way. Promat instead treat the mesh as one continuous cage around the sphere, strong enough to carry the Fendolite on its own. For design purposes the bond to the shell is ignored.

Before spraying

  • The sphere is loaded to its maximum, in service or with water, and stays loaded for at least five days after the last coat.
  • The shell and legs are blast cleaned to SA 2.5 and painted with a two-pack epoxy system.
  • One coat of PSK-101 is applied at 100 to 150 microns wet film thickness.

Collars and bands

Horizontal collars of Fendolite-MII, 200 to 300 mm wide, are sprayed around the sphere at 500 to 1,000 mm centres and levelled to about half the final thickness. Their job is to hold the mesh off the shell at the right depth. They are left rough and given at least 24 hours before the mesh goes on.

Mesh and support rings

  • On the shell: galvanised welded wire mesh, 76 mm or 100 mm square, in 2.5 to 3.0 mm wire with a tensile strength of at least 350 N/mm².
  • On the legs: 50 mm x 50 mm plastic coated galvanised mesh.
  • Two pairs of floating support rings, at roughly 0.3 and 0.5 of the sphere diameter, are hung from drop wires over the crown. The mesh is fixed in alternating strips between them.
  • Every overlap is at least two mesh apertures, tied with galvanised hog rings or wire.
  • No more than three layers of mesh overlap at any point.

Spraying and finishing

Fendolite-MII is then sprayed to the specified thickness, ideally in one coat, with a final coat of at least 8 mm. It must not be trowelled flush with the mesh, which would create a plane of weakness. Top surfaces and terminations are sloped to shed water, junctions with steel are sealed with mastic, and the cured surface is finished with an approved topcoat.

Quotations

Tell us the quantities and the delivery postcode and we will send a written quotation.

Request a quote